How to make a homemade bong?

Written by on 5 April, 2022

Bongs are one of the most used devices by smokers to get high and enjoy the weed; surely, you have used one before.

Well, buying one of these devices can be a bit expensive; luckily, you can make one yourself and solve those moments when you don’t have a way to smoke your weed.

Follow us and take note of how to make your own bong, it’s very easy, plus most of the materials you will need you will find at home. Be patient and get to work!

Bong with plastic bottle. What will you need?

– Small or large water bottle

– Water

– Pen

– Scissors

– Aluminum foil

– Needle

– Lighter

– Marijuana

Steps

1- To begin, fill the plastic bottle with water to ¼ of its capacity. You can use a small or large bottle, if it is large the better.

2- Then, with the help of a pen or any sharp tool, make a hole just below the neck of the bottle with water to make the carburetor.

Be careful not to cut yourself.

This is the hole that you first cover with your finger and then release to be able to inhale the smoke from the bottle, make sure it is not too big, but big enough to let the air in.

3- Proceed to make another hole, this time (the width of a feather) slightly above the water line, there you are going to introduce the stem and the dipper, you will place it at an angle so that the end inside the bottle is submerged in the water.

4- Get a fluorescent marker and aluminum foil to create the bong stem and bowl. What you need to do is empty the contents of the marker so that you are left with just the hollow plastic tube. Then take a piece of aluminum foil and wrap it around the end of the plastic tube.

Then press the center of the aluminum foil into the tube to make the cup. Make a few small holes with a needle.

5- Insert the open end of the marker that does not have the cup through the bottom hole you made earlier.

Place the stem tilted downwards and the bowl should be tilted upwards on the outside of the bottle.

6- Finally fill the bowl and you are ready to test your bong. When you are going to use it, cover the carburetor (the hole you made in the top of the bottle) with your finger.

Place your mouth on the mouthpiece of the bottle and light the bowl with a lighter. When you light it, inhale slowly through your mouth. Then, as the bottle fills with smoke, remove your finger from the carburetor and inhale the smoke.

 

 

 

 

 

 


Current track

Title

Artist